Справочник Пользователя для Hitachi VT-M181A

2. Using the 75 ohm cable supplied with your VCR, connect either end to the OUT TO 
TV upper jack on the back of the VCR. 
3. Use a second adapter to attach the other end of the 75 ohm connector back into the 
TV (where you first disconnected the antenna). 

 

Capabilities: With this hookup, you should now be able to perform all basic functions 
provided by this equipment. 

Plug in the TV and VCR power cords to the wall outlet or an appropriate extension cord 
or surge protector. See Important Safeguards for further precautions (page 6). 

The remote control requires two fresh "AA" batteries. On the back of the remote, a 
plastic cover  
slides off in the direction shown by the arrow.  Remove this cover and install the 
batteries, matching the plus end of each battery with the plus mark on the remote. 

 

When the VCR is on, its video signal can come into your TV on either channel 3 or 
channel 4.  You need to select the appropriate channel.  

 Turn the power on to both the TV and the VCR, and look for a switch on the back of 

the VCR.  Set the switch to 3 or 4, whichever is not a commercial channel in your area. 
Your basic hookup is now complete.  When you're ready to try hooking up a second 
VCR or a video camera for a complete home entertainment system, see Advanced 
Operations. 
Now turn the TV and VCR back around facing you and begin your quick tour of the 
controls (page 14).