Справочник Пользователя для honda-automobiles xr400
Tap the crank adapter with a soft mallet to help set it in
place. If you have a dial indicator it would be a good
time to check the run out.
Install the Joeracer key in the adapter making sure that
it is sitting flush and snug with no burrs folds spindles
or mutilations.
Next install the needle bearing over the adapter
making sure to grease well.
place. If you have a dial indicator it would be a good
time to check the run out.
Install the Joeracer key in the adapter making sure that
it is sitting flush and snug with no burrs folds spindles
or mutilations.
Next install the needle bearing over the adapter
making sure to grease well.
Now install part 3 from the clutch assembly sketch, paying attention to the correct direction the gear is
in-stalled.
The thin shim goes in the pocket of the gear facing out
in-stalled.
The thin shim goes in the pocket of the gear facing out
Now per the picture carefully install the clutch bearing
assembly in the hub (part 5 in to part 4) and then in stall
over the large gear assembly part 3
2