Руководство По Работе для Panasonic SC-PM11

RQT5706

Before using

Previous display

CLOCK

REC

PLAY

1
2

EQ-ON

CD MANAGER

REC

FWD

REV

AUTO OFF

/ REW /

/ FF/

DEMO

Setting the time

This is a 12-hour display clock.
This example in the figure shows how to set the time for 4:25p.m..

Switch on the power.

Press [CLOCK/TIMER] to select “CLOCK”.

Every time you press the button:

(within 7 seconds or so)

Press [g

g/REW/

3] or [4/FF/f

f] to show the

present time.

Press [CLOCK/TIMER] to finish setting the time.

The display will return to whatever was displayed before you
set the time.

To display the time when system is ON
Press [CLOCK/TIMER] to select “CLOCK”.

The time will be displayed for about 5 seconds and then the display
will return to whatever was previously displayed.

Note

The clock may lose or gain some time over a period. Readjust if
necessary.

Turning the demo function off

If the clock has not been set, a demonstration of the display is shown
when the unit is switched to standby.
This function is set to on at the time of purchase.

Press and hold [–DEMO] until “NO DEMO” is displayed.

This display changes each time the button is held down.
NO DEMO (off)

↔ DEMO (on).

Auto-off function

by remote control only

When CD or tape is selected as the source
To save power, the unit turns off if it is left unused for ten minutes.

Note

This function does not work if the source is tuner or AUX.

Press [AUTO OFF].
“AUTO OFF” is shown on the display.

To cancel
Press [AUTO OFF] again to clear “AUTO OFF” from the display.

For your reference
The setting is maintained even if the unit is turned off. When the unit is
turned on again, “AUTO OFF” is displayed and the unit functions as
described above.
“AUTO OFF” disappears from the display if either tuner or AUX is
selected as the source but continues to function normally.
“AUTO OFF” remains displayed if CD or tape is selected as the source.