Инструкции Пользователя для NAD C 546BEE

•  The power cord is disconnected.

•  Plug the power cord into the wall outlet 

securely.

•  No disc is inserted.

•  Insert a disc. 

•  The disc is loaded upside down.

•  Reload the disc with the label side UP.

•  The disc is too dirty.

•  Clean the disc.

•  The equipment connected with the audio 

cable is not set to receive CD signal output.

•  Select the correct input mode of the audio 

receiver so you can listen to the sound from 

the C 546BEE.

•  The power of the equipment connected with 

the audio cable is turned off.

•  Turn on the equipment connected with the 

audio cable.

•  The C 546BEE is subject to vibration or physical 

shock from external sources.

•  Change the installation location.

•  A mono plug is plugged-in at the +12V 

TRIGGER IN port of the rear panel.

•  Unplug the mono plug.

•  The remote control is not pointed at the 

remote sensor on the CD player.

•  Point the remote control at the remote 

sensor of the CD player.

•  The remote control is too far from the CD 

player.

•  Operate the remote control closer to the 

CD player.

•  The remote control batteries are dead.

•  Replace the remote control batteries.

HANDLING DISCS
Do not touch the playback side of the disc. Hold the disc by the edges so that 
fingerprints do not get on the surface. Never stick paper or tape on the disc.

STORING DISCS
After playing, store the disc in its case. Do not expose the disc to direct 
sunlight or sources of heat and never leave it in a parked car exposed to 
direct sunlight.

CLEANING DISCS
Fingerprints and dust on the disc can cause poor picture quality and sound 
distortion. Before playing, clean the disc with a clean cloth. Wipe the disc 
from the center out. 

Do not use strong solvents such as alcohol, benzine, thinner, commercially 
available cleaners, or anti-static spray intended for older vinyl records.