Справочник Пользователя для Contec DS110-APL
Setup
FX-DS110-APL
20
Power Supply Connection
There are two ways to connect the APL power supply.
Using the AC adapter provided with the unit
Connect the power adapter to a power outlet, and set the power
switch to 'DC.'
switch to 'DC.'
Using a UTP cable (requires the POW-CB10, sold separately)
To receive power from the UTP, set the power switch to 'UTP.'
The cable between the FX-DS110-APL and POW-CB10 should be
a UTP cable with category 5 specifications (maximum 30m).
a UTP cable with category 5 specifications (maximum 30m).
Using the AC adapter (included)
P OWER
WRX
WLINK
LIN K
RX
Using a UTP cable
POWER
WRX
WLIN K
LINK
RX
POWER
WRX
WLINK
LINK
RX
HUB
Cross cable *2
Straight cable *1
(max. 30m)
AC adapter
HUB
DC/UTP
DC/UTP
PC (NIC)
*1 Operates with the separately available cables TP-03 (3m), TP-05 (5m), TP-10 (10m), TP-20 (20m), TP-50 (50m).
*2 Operates with the separately available TP-X (30cm cross cable and attachment)
Note : The cable length between the unit and PC or hub should not exceed 90m.
UPLINK 8X 7X 6X 5X 4X 3X 2X 1X
Straight cable *1
Straight cable *1
POW-CB10
IN
D
ata
O
U
T
IN
AC adapter
UP LINK 8X 7X 6X 5X 4X 3X 2X 1X
IN
D
ata
O
U
T
IN
Figure 4.6. Power Supply Connection
Notes!
Never use any AC adapter other then listed below. Unauthorized
adapters may cause damage or accidents due to overheating.
adapters may cause damage or accidents due to overheating.
・ If the cable length between APL and POW-CB10 is between 10
and 30m, use the AC adapter supplied with the POW-CB10.
・ If the cable length between APL and POW-CB10 is 10m or less,
use the AC adapter supplied with the FX-DS110-APL.