Листовка для Metra AX-ADXSVI-GM3

™

© COPYRIGHT 2004-2011  METRA ELECTRONICS CORPORATION 

•  Connect the

Yellow wire to the radio’s 12 volt battery or memory wire.

•  Connect the

Black wire to the radio’s ground wire.

•  Connect the

red wire to the ignition wire of the aftermarket radio.

•  Connect the

orange wire to the illumination wire of the aftermarket radio. If the

aftermarket radio has no illumination wire, tape off the

orange wire.

•  The

orange/White wire will not be used in this application. Tape up or cap off

this wire and disregard it.

•  Connect the

Blue wire to the antenna turn on wire of the aftermarket radio.

•  Connect the

White wire to the left front positive speaker output of the

aftermarket radio.

•  Connect the

White/Black wire to the left front negative speaker output of the

aftermarket radio.

•  Connect the

 Gray wire to the right front positive speaker output of the

aftermarket radio.

•  Connect the

Gray/Black wire to the right front negative speaker output of the

aftermarket radio.

•  Connect the

Green wire to the radio’s left rear positive speaker output.

•  Connect the

Green/Black wire to the radio’s left rear negative speaker output.

•  Connect the

Purple wire to the radio’s right rear positive speaker output.

•  Connect the

Purple/Black wire to the radio’s right rear negative speaker output.

The following wires are for the aftermarket radios that have navigation built in.

•  Connect the

Light Green wire to the parking brake wire of the aftermarket navigation

radio (if applicable).

•  Connect the

 Blue/Pink wire to the VSS or speed sense wire of the aftermarket

navigation radio (if applicable).

Enhance your installation and fabrication skills by 

enrolling in the most recognized and respected 
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call 
800-354-6782 for more information and take steps 
toward a better tomorrow.

This product includes instructions for installation which must be carefully followed. The

instructions are worded in such a manner to assume that the installer is capable of

completing these type of electronic installations. If you are unclear as to what you are

instructed to do or believe that you do not understand the instructions so as to properly 

and safely complete the installation you should consult a technician who does have this 

•  Connect the

Green/Purple wire to the reverse wire of the aftermarket navigation

radio (if applicable).

•  Cycle the key, by turning the ignition on for 30 seconds. Then off and on again to

test the radio.

After the XSVI is initialized, plug in the ASWC-1 into the 12-pin harness of the

AX-ADXSVI-GM3 and refer to the ASWC-1 instructions.