Справочник Пользователя для Insys GPRS 5.0 Ethernet 11-02-01-03-10.018
Модели
11-02-01-03-10.018
Installation
INSYS GPRS 5.0 Ethernet
18
Dez-06
4
Installation
4.1
Initial Operation
Warning - General!
Please observe the safety instructions when putting the device into
operation.
Please observe the safety instructions when putting the device into
operation.
1.
Have the SIM card and PIN number ready, but do not insert the card yet.
2.
Connecting the power supply
a) Connecting the ground connection
b) Connecting the power supply 10…60V DC
Caution - Damage of components!
The minimum value is 10V DC.
The maximum value is 60V DC.
The maximum value is 60V DC.
3.
Connect the antenna and switch the power supply on.
Connect the antenna to the antenna connection using the FME plug and switch
the power supply on. The power LED will light up.
the power supply on. The power LED will light up.
4.
Wait until the device has powered up.
The status LED blinks during this process.
The signal LED blinks or lights up permanently when the process is com-
The signal LED blinks or lights up permanently when the process is com-
pleted.
5.
Connection to the PC
Connect the 10BaseT socket at the INSYS GPRS 5.0 Ethernet to the network con-
nection of your PC. For the configuration, you will need a crossover network ca-
ble.
The LED connect will light up as soon as the network cable has been connected
correctly.
nection of your PC. For the configuration, you will need a crossover network ca-
ble.
The LED connect will light up as soon as the network cable has been connected
correctly.