Техническая Спецификация для Meilhaus Electronic Mile House El.MML USB MEAS/switch RedLab® 1008

Table 4-4. Sample channel gain queue list 

0  

CH0  

BIP10V  

1  

CH0  

BIP5V 

2  

CH7  

BIP10V 

3  

CH2  

BIP1V 

When a scan begins with the gain queue enabled, the miniLAB 1008 reads the first 
element, sets the appropriate channel number and range, and then acquires a sample. The 
properties of the next element are then retrieved, and another sample is acquired. This 
sequence continues until all elements in the gain queue have been selected. When the 
end of the channel list is detected, the sequence returns to the first element in the list.  

This sequence repeats until the specified number of samples is gathered. You must 
carefully match the gain to the expected voltage range on the associated channel—
otherwise, an over range condition can occur. Although this condition does not damage 
the miniLAB 1008, it does produce a useless full-scale reading. It can also introduce a 
long recovery time from saturation, which can affect the next measurement in the queue. 

Table 4-5 lists the digital I/O connector, applicable cables and accessory equipment. The 
x in the compatible cable name indicates the length of the cable. 

Table 4-5. Digital connector and accessory equipment 

Connector type 

37 D-Type, shielded 
C37FF-x (Figure 4-13) 
C37FFS- x (Figure 4-14) 

Compatible cables 

C37FM- x (Figure 4-15) 

Compatible accessory products 

CIO-MINI37 
SSR-RACK24 
SSR-RACK08 
CIO-ERB24 
CIO-ERB08 

 

 

4-16