Техническая Спецификация для E-flite RTB 1220 mm EFL10550

1.   Install the landing gear (A) with the wheel pants pointed to the rear as 

shown.

2.  Install the covers (B, marked L and R) on the strut and fuselage.

3.   Install the fairings (C, marked L and R) on the fuselage using 4 screws (D).

When needed, disassemble in reverse order.

Tip: Carefully support the aircraft while installing or removing screws.

1.   Slide the horizontal tail tube (A) into the hole in the rear of the fuselage.

2.   Install the 2 piece (left and right) horizontal tail as shown. Ensure the 

control horn faces down.

3.   Install 2 screws (B) in the holes in the bottom of the horizontal tail.

4.   Attach the linkage (C) to the outermost hole in the elevator servo arm 

using the link keeper and to the elevator control horn using the clevis.

5.  Ensure the elevator servo arm is in the correct position, then adjust the 

linkage to center the elevator.

When needed, disassemble in reverse order.