Справочник Пользователя для Carson 1:8 RC model car Nitro Buggy 500204029
Модели
500204029
CARSON X8N Chassis
18
GB
Tools Needed for the Assembly
Scissors 300013305
Needle nose pliers
300074034
Side cutter
300074035
Modelling knife
300074053
Hexagonal wrench
300013118
Philips screwdriver (small and big)
and hex-wrench
1,5/ 2 / 2,5 mm
and hex-wrench
1,5/ 2 / 2,5 mm
300074023
Instant adhesive
300053339
Tweezers 300074003
Please read the instructions provided with your radio system before
using it.
using it.
The servos must be set at the centre position before installation. To set
the servos at a neutral position, turn on the transmitter and receiver.
Set the trim levers in the centre position and turn off the receiver, and
then the transmitter. The servos will be in proper neutral position for
installation.
the servos at a neutral position, turn on the transmitter and receiver.
Set the trim levers in the centre position and turn off the receiver, and
then the transmitter. The servos will be in proper neutral position for
installation.
Receiver antenna
Receiverbattery
Engine throttle
servo
servo
Steering servo
Switch
a. Your Radio System
(only for RTR version)
on)
Transmitter