Справочник Пользователя для Elitegroup 945GCT-M3
32
Using BIOS
If you are setting up a new hard disk drive that supports LBA mode, more
than one line will appear in the parameter box. Choose the line that lists
LBA for an LBA drive.
than one line will appear in the parameter box. Choose the line that lists
LBA for an LBA drive.
IDE Channel 0/1 Master/Slave IDE/Extended IDE Drives (Auto)
Leave this item at Auto to enable the system to automatically detect and configure
IDE devices on the channel. If it fails to find a device, change the value to Manual
and then manually configure the drive by entering the characteristics of the drive
in the items described below. Please noted that if you choose IDE Channel 2/3
in the items described below. Please noted that if you choose IDE Channel 2/3
Master, the item may change to Extended IDE Drive.
Refer to your drive’s documentation or look on the drive casing if you need to obtain
this information. If no device is installed, change the value to None.
this information. If no device is installed, change the value to None.
Before attempting to configure a hard disk drive, ensure that you have the
configuration information supplied by the manufacturer of your hard
drive. Incorrect settings can result in your system not recognizing the
installed hard disk.
configuration information supplied by the manufacturer of your hard
drive. Incorrect settings can result in your system not recognizing the
installed hard disk.
Access Mode (Auto)
This item defines ways that can be used to access IDE hard disks such as LBA (Large
Block Addressing). Leave this value at Auto and the system will automatically
decide the fastest way to access the hard disk drive. If you choose IDE Channel 2/
3 Master, the item only have Large and Auto.
Block Addressing). Leave this value at Auto and the system will automatically
decide the fastest way to access the hard disk drive. If you choose IDE Channel 2/
3 Master, the item only have Large and Auto.
Drive A (1.44M, 3.5 in.)
The item defines the characteristics of any diskette drive attached to the system.
You can connect one or two diskette drives.
You can connect one or two diskette drives.
Floppy 3 Mode Support (Disabled)
Floppy 3 mode refers to a 3.5-inch diskette with a capacity of 1.2 MB. Floppy 3
mode is sometimes used in Japan.
mode is sometimes used in Japan.
Video (EGA/VGA)
This item defines the video mode of the system. This motherboard has a built-in
VGA graphics system; you must leave this item at the default value.
Halt On (All Errors)
This item defines the operation of the system POST (Power On Self Test) routine.
You can use this item to select which types of errors in the POST are sufficient to
halt the system.
You can use this item to select which types of errors in the POST are sufficient to
halt the system.
Base Memory, Extended Memory, and Total Memory
These items are automatically detected by the system at start up time. These are
display-only fields. You cannot make changes to these fields.
display-only fields. You cannot make changes to these fields.
Press <Esc> to return to the Standard CMOS Features page.
Press <Esc> to return to Award BIOS CMOS Setup Utility page.
IDE HDD Auto-Detection
Press <Enter> while this item is highlighted to prompt the Setup Utility to
automatically detect and configure an IDE device on the IDE channel.