Справочник Пользователя для Behringer Europower PMP2000

Скачать
Страница из 12
7
EUROPOWER PMP2000 User Manual
3.  Effects Processor
24-Bit Multi-Effects Processor
This built-in effects module produces high-grade standard effects such as 
reverb, chorus, flanger, delay and various combination effects. The integrated 
effects module has the advantage of requiring no wiring. This way, the danger 
of creating ground loops or uneven signal levels is eliminated at the outset, 
completely simplifying the handling. These effect presets are designed to be 
added to dry signals. If you move the FX TO MAIN/MON control, you mix the 
channel signal (dry) and the effect signal.
◊ 
Turn down the FX controls in those channel strips whose signals you 
don’t wish to process.
4.  Installation
4.1  Mains voltage
Before connecting the PMP2000 to the mains, please carefully check that your 
equipment is set to the correct voltage! Blown fuses must be replaced by fuses of 
the same type and rating!
4.2  Mains connection
The mains connection is made using the enclosed power cord and a standard IEC 
receptacle. It meets all of the international safety certifi cation requirements.
◊ 
Please make sure that all units have a proper ground connection. 
For your own safety, never remove or disable the ground conductor 
from the unit or of the AC power cord.
4.3  Audio connections
The in and outputs of your BEHRINGER PMP2000 are designed as unbalanced 
¼" mono jacks—except for the mono channel line inputs, which come as 
balanced ¼" stereo jacks. Of course, all in and outputs work with both balanced 
and unbalanced connectors. The tape ins and outs are on stereo RCA connectors.
◊ 
Please ensure that only qualified personnel install and operate the 
PMP2000. During installation and operation, the user must have 
sufficient electrical contact to earth. Electrostatic charges might affect 
the operation of the unit.
strain relief clamp
sleeve
tip
sleeve
(ground/shield)
Unbalanced ¼" TS connector
tip
(signal)
Fig. 4.1: ¼" mono plug
strain relief clamp
sleeve
ring
tip
sleeve
ground/shield
For connection of balanced and unbalanced plugs,
ring and sleeve have to be bridged at the stereo plug.
Balanced ¼" TRS connector
ring
cold (-ve)
tip
hot (+ve)
Fig. 4.2: ¼" stereo plug
For unbalanced use, pin 1 and pin 3 have to be bridged
1 = ground/shield
2 = hot (+ve)
3 = cold (-ve)
input
1
2
3
output
1
2
3
Fig. 4.3: XLR connectors
strain relief clamp
sleeve
tip
sleeve
pole 1/ground
tip
pole 2
The footswitch connects both poles momentarily
¼" TS footswitch connector
Fig. 4.4: ¼" TS connector for footswitch