Краткое Руководство По Установке для Whirlpool WDF550SAAW

1. Using 2 or more people, place the dishwasher on its back on a 

piece of cardboard.

2. Using a Phillips screwdriver, remove the 4 screws attaching

 the toekick panel and lower panel to the dishwasher.

3. Remove both panels and set aside on a protected surface.
4. Apply thread seal tape to 90º elbow fitting and connect fitting 

to water inlet valve.

5. Tighten elbow until snug.

NOTE: Elbow should face to the rear of the dishwasher.

terminal box cover.

■

Direct Wire—Install a U.L. listed/CSA certified clamp 
connector to the terminal box. If using conduit, use a U.L. 
listed/CSA certified conduit connector.

■

Power Supply Cord—Install a power supply cord kit that is 
U.L. listed and marked for use with dishwashers (Part 
Number 4317824).

7. Measure the shortest opening height between the underside 

of the countertop and the floor where the dishwasher will be 
installed.

8. Extend leveling legs out from the dishwasher base, 

¹⁄₄" less 

than the shortest opening height.

A

A

B

A

6. Remove top screw and slide cover to the right to remove 

1. Using 2 or more people, place the dishwasher upright in front 

of cabinet opening.

2. With one person holding the dishwasher to avoid tipping, 

open and close the dishwasher door a few times. If the door 
closes too quickly or falls open under its own weight, adjust 
the tension.

■

If the door closes too quickly, decrease the spring tension 
by pulling the spring adjustment pin out of its hole and 
reinsert it into the next lower hole toward the back of the 
dishwasher.

■

If the door falls open, increase the spring tension by 
pulling the spring adjustment pin out of its hole and 
reinserting it into the next higher hole toward the top 
of the dishwasher.

NOTE: The spring adjustment pins should be in the same holes 
on both the left-hand and right-hand sides of the dishwasher.

1. Using 2 or more people, grasp the sides of the dishwasher at 

the edges of the door panel and move dishwasher close to the 
cabinet opening.

NOTE: Do not push on the front of the panel or on the console 
to avoid bending or denting them.

■

Do not remove the tie wrap in the top holes.  The top
two holes should not be used.