Краткое Руководство По Установке для Whirlpool WDF550SAAW

■

A hot water line with 20-120 psi (138-862 kPa) water pressure.

■

120°F (49°C) water temperature at dishwasher.

■

³⁄₈" O.D. copper tubing with compression fitting or flexible 

braided water supply line

.

NOTE: ½" minimum plastic tubing is not recommended.

■

90º elbow with 

³⁄₈" N.P.T. external pipe threads on one end.

IMPORTANT: Do not solder within 6" (15.2 cm) from water inlet 
valve.

■

Use the new drain hose supplied with your dishwasher. 

NOTE: If a longer drain hose is required:

■

Use a new drain hose with maximum length of 10 ft (3 m) 
that meets all current AHAM/IAPMO test standards

■

Use a new drain hose that is resistant to heat and 
detergent

■

Use a new drain hose that fits the 1" (2.5 cm) drain 
connector on the dishwasher.

■

Connect drain hose to waste tee or disposal inlet above drain 
trap in house plumbing.

■

Connect drain hose to house plumbing 20" (50.8 cm) 
minimum above the floor. 

NOTE: It is recommended that the drain hose either be looped up 
and securely fastened to the underside of the counter, or be 
connected to an air gap.

■

Use a drain air gap if the drain hose is connected to house 
plumbing lower than 18" (45.7 cm) above the subfloor or floor.

■

Use ½" (1.3 cm) minimum I.D. drain line fittings.

NOTE: Do not connect drain lines from other devices to the 
dishwasher drain hose.

1. Disconnect power.
2. Turn off water supply.

Follow the steps in this section if you are installing the dishwasher 
in an existing cabinet opening with utility hookups.
1. Check that the water supply line reaches to the front left-hand 

side of the opening where the water connection will be made.

2. Check that the direct wire reaches to the front right-hand side 

of the opening where the electrical connection will be made.

IMPORTANT: Always use a new drain hose even when installing 
a new replacement dishwasher.

3. Drill a 1

¹⁄₂" (3.8 cm) diameter hole in the cabinet wall or floor on 

the side of the opening closest to the sink.

1. Remove the waste disposal knockout plug. Cut the end of the 

drain hose, if needed.
NOTE: Do not cut the ribbed section.

2. Attach the drain hose to the air gap with the large spring-type 

clamp.
NOTE: If the drain hose was cut, use 1

¹⁄₂" to 2 " (3.8 to 5 cm) 

screw-type clamp (not provided).

3. Use a rubber hose connector (not provided) with spring- or 

screw-type clamps (not provided) to connect the air gap to the 
waste disposal inlet above the drain trap and at least 
20" (50.8 cm) above the floor.

-