Справочник Пользователя для Sprint Nextel SP-809
10
Installation
MOUNTING THE BASE ON A WALL
Note: To mount the base directly on the wall, you need two screws
(not supplied) with heads that fit into the keyhole slots on the bot-
tom of the base. Drill two holes 3
(not supplied) with heads that fit into the keyhole slots on the bot-
tom of the base. Drill two holes 3
15
/
16
inches (100 mm) apart, one
above the other. Then thread a screw into each hole, letting the
heads extend about
heads extend about
5
/
16
inch (7 mm) from the wall.
1
Press and lift out the
handset holder, turn it over
and rotate it 180°, then slide it
back into place so it holds the
handset.
and rotate it 180°, then slide it
back into place so it holds the
handset.
2
Remove the bracket by
pressing the indentation and
gently pulling out the wide
end of the bracket.
gently pulling out the wide
end of the bracket.
3
Plug one end of the sup-
plied short modular cord (or
long modular cord if mounting
directly on the wall) into the
long modular cord if mounting
directly on the wall) into the
LINE
jack and the supplied
AC adapter’s barrel plug into
the
the
POWER
jack on the back
of the base.
LINE Jack
POWER Jack
43-5809.fm Page 10 Wednesday, August 18, 1999 1:43 PM