Справочник Пользователя для Smithco Automobile 78-200-A
10
Service
ADJUSTMENTS
ADJUSTMENT OF BELT TENSIONER
There are two belt tensioners on the Sweep Star V62. One
controls the tension on the belt from the engine to blower
shaft the other controls the belt on the finger or brush reel.
The proper tension of the idler should be 12 to 15 as per the
gauge (A) on the side of the tightener. Over tightening the belt
will shorten the life of the belt and the machine may not per-
form to the best of its ability. To adjust belt tensioner, loosen
bolt holding tensioner. Bring idler pulley tight to belts and turn
tensioner into belts to 15°. Tighten holder bolt.
controls the tension on the belt from the engine to blower
shaft the other controls the belt on the finger or brush reel.
The proper tension of the idler should be 12 to 15 as per the
gauge (A) on the side of the tightener. Over tightening the belt
will shorten the life of the belt and the machine may not per-
form to the best of its ability. To adjust belt tensioner, loosen
bolt holding tensioner. Bring idler pulley tight to belts and turn
tensioner into belts to 15°. Tighten holder bolt.
CASTOR WHEELS
Install castor wheels onto the brush/finger head assembly. You may put the machine bush-
ings and spacers (A) on in any combination to get desired height. You should leave one
machine bushing on the very bottom and one on the very top next to the lockpin. Check the
tire pressure on Castor Wheels they should be 20 psi (1.4 bar).
ings and spacers (A) on in any combination to get desired height. You should leave one
machine bushing on the very bottom and one on the very top next to the lockpin. Check the
tire pressure on Castor Wheels they should be 20 psi (1.4 bar).
STORAGE
When storing, remove the key from the key switch to avoid unauthorized persons from operating machine.
1. Before storing clean machine thoroughly.
2. Check bolts and nuts, tighten as necessary.
3. Make all repairs that are needed and remove any debris.
4. Remove the battery, adjust the electrolyte level and recharge it. Store the battery in a dry, dark place.
5. Store in a clean and dry area, but NOT near a stove, furnace or water heater which uses a pilot light or any
device that can create a spark.
6. Engines stored over 30 days need to be protected or drained of fuel to prevent gum from forming in a fuel
system or on essential carburetor parts. Check the engine manual and follow the instructions for the
storage of the engine.
storage of the engine.