Справочник Пользователя для Recoton/Advent Acoustic Research Wireless AW811

4

There are two options to power your wireless speaker: 

This product is designed to work with line level outputs or

headphone outputs only. DO NOT connect it directly to speaker outputs as it
will permanently damage the transmitter.

If you are using rechargeable batteries NiMH or NiCd, the batteries will 
charge when the speaker is powered with the AC power adapter. Please DO 
NOT power the speaker with the AC power adapter if you installed alkaline 
or other non-rechargeable batteries – this could cause the batteries to leak, 
which would damage the speaker.

1. Turn the speaker volume down by 

rotating the power/volume/scan 
control (B) on the side of the 
speaker all the way to the left.

2. Insert the small, round plug from 

the speaker AC power adapter (N) 
into the speaker power input jack 
(C).

3. Plug the other end of the speaker 

AC power adapter into any 
standard 120V AC wall outlet. 

Be sure to use the speaker 

AC power adapter rated 15V DC 
800 mA.

1. Turn the speaker volume down by 

rotating the power/volume/scan 
control (B) on the side of the 
speaker all the way to the left.

2. Remove the battery compartment 

cover (G) on the bottom of the 
speaker.

3. Insert eight (8) C-cell batteries (not

included) into the speaker 
following the polarity 
(“+” and “–”) as diagrammed 
inside the battery compartment.

Place the rubber cap in the 

speaker power input jack (C) when
using batteries.

This product is water resistant, not waterproof. To avoid electrical

shock, it should be used with caution near water sources if powered with the
AC adapter. Never submerge in water.