Справочник Пользователя для Pertech 5300

Pertech provides a Logo Download Utility to simplify the adding of logos or Bit Mapped images to your printed tickets 

or receipts. The utility is available for download from the Pertech web site. 

This utility allows BMP (Bitmap) graphic files to be down-

loaded into Pertech Resources printer memory for later 

printing.  BMP graphics can be stored in non-volatile 

Flash or RAM.  

The BMP Download Utility can be used on either the 

5300 series printers, or the A470e printers.

The utility may be configured to download using one of 

two communication types: RS232 or USB.  RS232 may 

be configured to use hardware or software handshak-

ing, baud rates 1200, 2400, 4800, 9600, 19200, 38400, 

57600 on a choice of COM ports 1-9.  

Before using the utility to download BMP files, the user 

should verify the host communication settings match the 

connection to the printer.  The communication settings 

used to transmit information to the printer are displayed 

on the bottom of the form.  If the settings are incorrect, 

you may click on the “Setup” menu, then select “Com-

munications”.  See the “Modify Host Communications” 

section of this document for more information.

The printer must be configured so that the “Printer Con-

trol Language” is set to “ACL Language”.   This can be 

verified by printing a configuration ticket on the printer:  

Turn off power to printer, press and hold the paper feed 

button.  While holding the feed button down, turn on the 

printer power.  Release the button after the printer has 

finished centering the printhead.  

Features

The “Add” button will open up a browser window to 

select a BMP file and add it to the list of BMP files to 

download.  The BMP files must be monochrome and no 

larger than 368 pixels wide.

The “Remove” button will take a selected file off of the 

list of BMP files to be downloaded.

A “Destination Memory” must be selected, either FLASH 

or RAM.  This selection will choose which type of mem-

ory where the BMP will be stored in the printer when the 

“Send BMP(s)” button is clicked.  It will also choose the 

type of memory to be erased (“Erase Selected Memory”) 

and the amount of total memory available (“Selected 

Memory Available”).

  

Modify Host Communications

Setting the communications is done in the dialog box 

shown above.  One of 2 interfaces may be checked, 

RS232 or USB. 

RS232: For RS232 connections, the baud rate and 

handshaking method must match how the current printer 

is configured.  If you are unsure how the printer is con-

figured, print a self-test (hold the feed button and cycle 

power).  Make sure that a null modem cable is connect-

ed between the selected COM port and the printer.

USB:  USB connections do not require any special pa-

rameter settings.  (Windows 98 users may need to check 

the “Troubleshooting” section of this document.)

Click on OK when the interface and parameters match 

those of the connected printer.