Справочник Пользователя для Qualstar 501440 Rev. G
6.5
Installing a Fibre Channel Option
CAUTION
Be sure to turn the library’s power off before installing or removing a Fibre Chan-
nel Option.
6.5.1 Installation
The following steps outline the actions necessary to install a Fibre Channel Option
onto a library.
onto a library.
1.
Remove power from the TLS: first turn the power switch off and then remove the
power cord.
power cord.
2.
Using a Phillips screwdriver remove the six screws securing the service panel on
the rear of the library – refer to Figure 6-9. Depending of the model of library,
the service panel may not have ventilation slots. Care must be taken to not re-
move the four screws securing the heatsink panels. Save the service panel for
possible future use.
the rear of the library – refer to Figure 6-9. Depending of the model of library,
the service panel may not have ventilation slots. Care must be taken to not re-
move the four screws securing the heatsink panels. Save the service panel for
possible future use.
Phillips Screws (6)
Do not remove
these screws
Do not remove
these screws
these screws
Figure 6-9 Service Panel
3.
Place the lower lip of the FCO inside the bottom edge of the service panel open-
ing and tilt the FCO upwards, making sure that the heatsink panel screws align
ing and tilt the FCO upwards, making sure that the heatsink panel screws align
501440 Rev. G
FCO Type C Installation
6-11