Справочник Пользователя для NewAir ADW-2600W

Скачать
Страница из 24
 
 
Remember: 
•  Inspect all filters before every cycle to ensure there are no food particles. 
•  By unscrewing the coarse filter, the entire filter assembly can be removed.  Always 
remove food remnants and clean the filters by placing them under running water. 
 
NOTE: The entire filter assembly should be cleaned once a week. 
 
Cleaning the Filter 
Use a cleaning brush to clean both the coarse filter and the fine filter.  Reassemble all filter parts 
as shown in the diagram and re-insert entire filter assembly into the dishwasher by positioning 
and pressing down. 
 
WARNING:  When cleaning the filters, do not hit them against a surface.  This could 
cause the filters to become misshaped and potentially affect the dishwasher’s 
performance. 
 
Maintaining Your Dishwasher 
Clean your control panel by using a lightly damp cloth.  Finish by drying thoroughly. 
To clean the exterior, use a wax specifically designed for dishwashers. 
Never use any sharp objects, scouring pads or harsh chemical cleaners on any part of your 
dishwasher. 
 
Cleaning the Door 
Clean the edge around the door with a soft cloth that is lightly damp.  Never use any type of 
spray cleaners to ensure that water does not enter the door lock and affect electrical 
components. 
 
WARNING!  
•  Never use a spray cleaner to clean the door panel.  The door lock and electrical 
components may be damaged. 
•  Never use abrasive cleaning products or rough towels to avoid scratching or 
leaving spots on the stainless steel surface. 
 
Protection against Freezing 
 
During the winter months, implement the following procedures after each wash cycle to prevent 
water lines from potential damage: 
1.  Cut off all electrical power to the dishwasher. 
2.  Turn off the water supply and disconnect the water inlet pipe from the water valve. 
3.  Drain water from both the inlet pipe and the water valve.  You can use a pan to catch 
any water. 
4.  Reconnect the water inlet pipe to the water valve. 
5. 
Remove the filter at the bottom of the dishwasher tub.  You can use a sponge to soak 
up excess water in the sump. 
 
NOTE: If your dishwasher stops working due to ice, please contact an authorized service 
department. 
 
 
 
12