Справочник Пользователя для KUHN RIKON Kuhn Rikon Corp. Drill 30-100

Assembly

6. The feed handle (A-Fig.06) is secured to the

feed shaft with the supplied Allen bolt

(B-Fig.06).

Fig.06

7. Depth Stop: The depth stop and scale are

found on the left side of the switch box. To

adjust, lower the drill chuck until pointer shows

desired depth on the scale

. Loosen the

lower nut on the threaded shaft

(A-Fig.07) until

it bottoms out on the head casting (B-Fig.07).

Tighten upper nut against the lower nut to

retain the adjustment.

Fig.07

8. Table Tilt: The drill press table will tilt 0-45

degrees left and right. To tilt, loosen the nut

located under the table (A-Fig.08). Align the

“zero” mark on the table (B-Fig.08) to the

desired degree marking on the scale. Tighten

the nut under the table to retain the

adjustment.

Fig.08

Adjustments