Справочник Пользователя для K-Tec MT2000

 

24                                                                                                                     MT2000-0200-01 Rev f (10-2007) 

DCN0160

 

END (CFG MENU) 

RNG - Range 

LTP - Low Trim Point 

HTP - High Trim Point 

LTC -  Low Trim counts 

HTC - High Trim counts 

TMP - Module Temperature 

SOR - Signal Out of Range  

 

LRM - Low Range Margin 

 

LRS - Low Range mA 

SAT 

END 

LL1 - Liquid Level 1 

(Main Menu) 

Select 

UP/DOWN 

Arrow 

The sensor trim is now complete and the LRV has been set to equal 0 and URV has been set to the value of HTP. If 
other LRV and URV are desired, then proceed to the CAL menu and change LRV and URV accordingly. 
 
If the level cannot be moved, the transmitter must be removed for re-trimming.  Please contact the factory before 
trimming to confirm the procedure to follow. Should the trim be suspected of being corrupted, please consult the fac-
tory.  The transmitter can be brought back to the factory calibration conditions by performing a “3 Button Reset”.  
This is accomplished by simultaneously pressing “UP”, “DOWN” and “SELECT”.  This action is generally recom-
mended as a “last resort” prior to returning the transmitter to the factory for analysis, repair (if needed) and re-
calibration. 
 

SAT 

ALRM 

 
These functions are accessed by pressing the ‘UP’ and ‘DOWN’ buttons together, when the LCD display is on 
‘END’ at the end of the CFG menu.  Enter the Sensor Trim menu and scroll down to access the following func-
tions: