Справочник Пользователя для Hughes DIRECWAY DW4020

Скачать
Страница из 136
Appendix C • Installing the DW4020 Manually
92
1031484-0001 Revision 2
Gateway LEDs flash, receive
modem READY LED off or
flashing
If the Gateway does not seem to be functioning and its STATUS 
LED flashes amber, and the receive modem READY LED blinks 
or is not lit, as shown in Figure 68, take the following steps.
• Check to make sure the USB cable is securely attached to the 
Gateway and receive modem. See Figure 66. If the cable was 
loose, the Gateway and receive modem READY LEDs will 
come on when it is reattached.
• If securing the USB cable does not solve the problem, check 
all cable connections. Tighten any that seem loose.
• If the Gateway STATUS LED still does not come on 
continuously, power cycle the DW4020 by unplugging the 
power cord from the wall outlet or surge protector, waiting 
ten seconds, and plugging it back in.
• If the problem persists, contact technical support.
LED blinking indicating
status codes
The DW4020 modems’ READY LEDs can blink in various 
patterns. These patterns correlate to the status codes discussed in 
Transmit Status messages on page 37 and Receive Status 
messages
 on page 42. If
 you can see the patterns, you also have 
access to the 
User Interface
. It will be easier to find out what the 
status of the DW4020 is via the interface than the LED status 
Figure 69: Gateway STATUS LED blinks amber
Receive modem READY 
LED blinks or is not lit
Gateway STATIS LED 
blinks amber