Справочник Пользователя для Hitachi GR2000-B Series

Setup Process

GR2K-GA-0008

2-13

Rev. 1.00

2.9.5

Turning the Power Switch ON

The power switch for the GR2000-B is a rocker switch located next to the power cord
on rear panel. Operate the switch to turn power ON (1) or OFF (0). Turn on the power
at the back of the GR2000-B.

Figure 2-16 Switching Power ON and OFF

2.10

Normal Start-Up Process for the GR2000-B

Below is the process from powering on the device to starting it.

1. The STATUS RMP indicator starts blinking green as soon as the system is

powered ON.

2. The GR2000-B begins loading it’s software when the ACC (access) indicator lights

in green. During this time, the STATUS RMP indicator continues to blink.

3. The STATUS RMP indicator lights solid green after the software has loaded. The

system then starts up normally.

2.10.1

Turning the Power OFF

Turn the power switch at the back of the GR2000-B to OFF (0)

Note: The STATUS RMP or STATUS ETHERNET indicator showing red indicates

trouble. For details, see the Hitachi Gigabit Router GR2000 Series Enhanced
Version Operations Guide.

Caution: If a memory card is not installed, the GR2000-B stops running while showing

"20" in the STATUS CODE display. Power off the GR2000-B and install a
memory card, then power it on again.

Caution: While the access indicator (ACCESS) for a memory card is lit, the memory

card is being accessed. DO NOT pull out a memory card or turn off the
power switch while the memory card is being accessed. If so, you could
permanently damage the memory card.

Some commands require a long time to finish accessing a memory card
when they are executed. Make sure that the access to a memory card is
finished before pulling it out or turning off the power switch.

Power Switch

OFF