Справочник Пользователя для Graco 332230EN-F

NOTE: Glass bead system and paint guns can be 
mounted on either side of sprayer. 

1. Turn off unit. Relieve pressure in paint striper and 

remove hopper. 

2. Locate belt shroud. Loosen four screws (A) and 

remove shroud (B). 

3. With belt guard off, install mounting plate coupler 

(C) onto pulley (D) with two shoulder screws (E) and 
serrated nuts. Position slot on back of pulley up and 
move serrated nut with finger to accept shoulder 
bolt threads. Tighten shoulder bolt by hand until the 
teeth on the serrated nut catch the aluminum on the 
fan. Torque shoulder bolt to 16 to 18 ft-lb (21 to 24 
N•m) to secure mounting plate coupler.

4. Use existing hardware to install new open-centered 

fan grill (F). Make sure fan protrudes out, not into 
the unit. Discard or store old close-centered fan grill. 

5. Install belt shroud with new fan grill onto unit. 

NOTE: You may need to flex shroud around 
extended shaft on the fan pulley. 

6. Place key (G) in keyway opening. Tap into place so 

that face of key sits recessed slightly from face of 
hub.

7. Push chain coupler against the shoulder on the 

mounting plate coupler.

8. Use 1/8 in. Allen wrench to secure coupler set 

screw. Torque to 58-62 in-lb (6.6-7.0 N•m).

ti20518a

B

A

ti20525a

D

C

E

ti20519a

Shroud

Shroud

F

ti20518a

B

ti20516a

G

ti24336a