Справочник Пользователя для Bakers Pride BLF-FC

25 

 

•  Make certain that the rinse hose is connected to rinse hose connector.  

 

•  Holding the hose by the handle, place hose nozzle inside the pot. 

•  Position the FILL lever in the THRU HOSE position. 

 

• Position 

the 

FILTER/OFF/FRY switch to FILTER and shortening will automatically pump 

into the pot.  

 

•  Let the filter continue to pump the shortening until the fill mark in the fryer pot is reached 

or until air starts bubbling through the shortening.  

 

•  As soon as air is seen in the shortening, position the FILTER/OFF/FRY switch to OFF to 

prevent shortening degradation.  
 

•  Add new shortening if the fill mark has not been reached. 

Boil-outs remove microscopic particles of carbon that build up on the walls of the fryer pot. To avoid 
eventual carbon build-up, off flavors, and shortening breakdown, boil-outs should be done once a week 
on each fryer following these procedures. 

 

Always wear appropriate personal protection equipment during the boil-out 
process to guard against possible injury from hot cleaning solution. 

 

1. Position 

the 

FILTER/OFF/FRY switch to OFF. 

 

2.  Drain the clean shortening into an adequate storage container. (Allow the shortening to cool to 

room temperature before attempting storage.) 
 

3.  CLOSE the drain and fill the fryer pot with HOT water to the shortening level fill mark. Do not 

overfill by allowing the water level higher than the fill mark. 
 

4.  Add ½ cup (4 ounces) of BKI cleaner. 

 

5.  Wash down the inside of the pot with the pot brush to loosen the sediment.