Справочник Пользователя для Woodstock THE SHOP FOX D2677

-12-

GET.help.to.lift.the.head-

stock,. or. you. may. seri-

ously. hurt. your. back. or.

drop.the.headstock..

The headstock is secured with a set screw so it

is aligned with the drill press base for balance

and weight distribution.

DO.NOT over tighten

the set screw, or you will bend the column or

strip the threads.

Headstock

To.install.the.headstock.assembly,.do.these.

steps:

1.. Place the locking gib into the recessed

pocket on the inside of the column bracket

casting (see

Figure.14).

2. With an assistant, lift and position the

headstock pocket over the column and

allow the headstock to slide down until

the column fully seats into the headstock

(approximately 2", see

Figure.15).

3.. Rotate the headstock directly over the foot

of the base as viewed from the front of the

drill press.

4. Screw in the two lock handles on the sides

of the headstock.

5. Using a plumb bob and ruler, center the

headstock with the base, and tighten the

two set screws to secure the headstock to

the column (see

Figure.16).

Figure.14..Locking gib installation.

Figure.15. Headstock-to-column installation.

Figure.16..Aligning the headstock.

Locking

Gib

ASSEMBLY