Справочник Пользователя для Woodstock THE SHOP FOX D2677

To drill wide workpieces up to 34" in diam-

eter, you can slide the headstock in and out

to increase the distance between the drill

chuck and the column up to 17". You can also

tilt the headstock from 45° clockwise to 90°

counterclockwise for drilling angled holes or for

horizontal boring machine use. Using the slide

and tilt features, you can drill a line of straight

or angled holes without the need to reposition

your workpiece after drilling each hole.

To.use.the.headstock-sliding.feature,.do.

these.steps:

1. Loosen the lock lever located on the right

side of headstock (see

Figure.31).

2.. Turn the slide knob to move the headstock

back and forth to desired position and then

tighten the lock lever (see

Figure.31)..

To.use.the.headstock-tilting.feature,.do.

these.steps:

Note: If the scale is not calibrated, set the

table to zero degrees, zero the headstock with

the table, and then reposition the scale to zero

degrees.

1.. Loosen the lock handle on the right side of

headstock (see

Figure.31).

2.. Pull out the guide pin knob located on the

left side of the headstock and rotate the

pin knob 90° so the pin stays disengaged

from the horizontal column (see

Figure.

32).

3.. While reading the tilt scale, tilt the head-

stock to your desired angle and tighten

lock lever (see

Figure.31).

4.. Drill your workpiece.

5.. Loosen lock handle located on the right

side of headstock, and tilt the headstock

to zero and move the guide pin back into

the guide slot.

6.. Tighten the lock lever.

Headstock

Figure.31. Headstock tilt and slide controls.

Figure.32..Headstock guide pin and knob.

Lock

Lever

Slide

Knob

Guide Pin

and Knob

Horizontal Column

OPERATIONS