Справочник Пользователя для Bunn FPG-2

30

P1745

FIG. 20 CAPACITOR

Location:

  The capacitor is located inside the front panel of 

the hopper housing next to the Off/On/Start switch.

Test Procedure:

1.  Disconnect grinder from the power source.

2.  Visually inspect the capacitor for leakage. If leakage 

is visible, replace the capacitor.

3.  Connect the grinder to the power source, if the mo-

tor does not run, disconnect the capacitor wiring 

harness from the main wiring harness. If the motor 

now runs, replace the capacitor.

P1747

FIG. 21 CAPACITOR TERMINALS

1. 

Place f

ilter

 into

 funne

l and s

lide 

funn

el int

o rai

ls.

2. 

Mom

enta

rily 

pus

h th

e sw

itch

 to "S

TAR

T" po

sitio

n.

3. 

Grinde

r wi

ll au

toma

tica

lly st

op w

hen 

finished

.

+

BLK

WHI/BRN

Removal and Replacement:

1.  Disconnect the capacitor wiring harness from the 

main wiring harness.

2.  Remove the #8-32 nut attaching the capacitor and 

mounting bracket to the hopper housing and remove 

the bracket, shield, capacitor and capacitor wiring 

harness as an assembly.

3.  Disconnect the wiring harness from the capacitor 

and attach it to a new capacitor making sure the 

black wire attaches to the positive (+) pole, FIG. 

21.

4.  Wrap the shield around the capacitor and place into 

the mounting bracket. Slide the lower tab of the 

mounting bracket between the wrapper and base 

and secure in place over the mounting stud with 

the #8-32 nut.

5.   Reconnect the wiring harness to the main wiring 

harness.

41545 122209