Справочник Пользователя для Bunn FPG-2

52

Location:

The membrane switch is located on the front of the 

hopper housing.

Test Procedure:

1.  Press and hold the right hidden button to enter 

programming.

2.  Scroll through the menus to Service Tools and 

select YES.

3.  Select YES at Test Outputs and scroll through to 

Test Switches by pressing NEXT.

4.  Follow the chart below to test all switches.

If any of the switches indicate a fault, replace the 

membrane switch.

FIG 57 MEMBRANE SWITCH

PRESSING ANY BUTTON

EXCEPT THE RIGHT HIDDEN

BUTTON WILL DISPLAY

THE BUTTON NAME

ON THE SCREEN

Removal and Replacement

1.  Disconnect the grinder from the power supply.

2.  Remove the rear access panel.

3.  Disconnect the membrane switch harness from the 

control board.

4.  Carefully peel the membrane switch from the front 

of the switch bezel.

5.  Remove any excess adhesive from the bezel sur-

face.

6.  Remove the backing from the new membrane 

switch.

7.  Feed the membrane switch harness through the 

openning and apply the new membrane switch to 

the switch bezel.

8.  Connect the switch harness to J9 on the display 

board.

41545 122209