Инструкции По Установке для Dacor DYRTP486SNGH

Verifying Proper Operation

•  Make sure that power to the electrical outlet is turned 

off at the circuit breaker or fuse box and that the gas 

is turned off at the gas supply valve before proceed-

ing.

•  The rangetop must be properly grounded at all times 

when electrical power is applied. 

Prior to operating the rangetop, read the accompanying use 

and care manual carefully.
1.  Make sure all the 

rangetop burner con-

trols are in the 

OFF 

position.

2.  Connect the power 

cord to the electrical outlet.

3.  Turn on power to the electrical outlet at the circuit 

breaker panel or fuse box.

4.  Gently push in and turn one of the burner control knobs 

counterclockwise to the 

HIGH position. Verify that the 

associated burner igniter sparks, then return the knob 

to the 

OFF position. Repeat for all of the remaining 

burner knobs.

5.  Turn on the gas supply valve.
6.  Perform the following ignition test for all of the burners, 

one at a time:

•  Push in and turn one of the control knobs counter-

clockwise to the 

HIGH position. Only the igniter for 

the selected burner will spark. It may take up to four 

seconds for the gas to ignite, at which time the ignit-

er will stop sparking. If ignition does not occur within 

four seconds, turn the knob to the 

OFF position, wait 

for at least five minutes to allow any gas to dissipate, 

then repeat the test.

•  Once the burner lights, the control knob can be rotat-

ed counterclockwise from 

HIGH to LOW to adjust the 

flame height progressively.

•  When the unit is installed properly, the flame will be 

steady. It will also have 

a sharp, blue inner cone 

that will vary in length 

proportional to the 

burner size. The flame 

will be reduced by the 

Smart Flame™ feature 

under the grate fingers 

to increase grate life.

these troubleshooting steps:
•  Verify that power and gas are supplied to the rangetop.
•  Check to make sure that the power plug is connected 

to the electrical outlet and that power is turned on at 

the circuit breaker panel or fuse box.

•  Check to make sure that all burner parts are properly 

seated.

•  If the burner continues to spark after ignition without 

stopping, have a licensed electrician check the electri-

cal outlet for proper grounding or reversed polarity.

•  Repeat the burner ignition test.
If the appliance still does not work, contact Dacor 

Distinctive Service at (800) 793-0093 ex 2822. Do not 

attempt to repair the appliance yourself. Be sure to have 

the model and serial numbers available when you call. See 

the inside cover for location.
Dacor is not responsible for the cost of correcting problems 

caused by a faulty installation.

Removing the Rangetop for 

Repair

To remove the appliance for repair, perform the installation 

process on the previous pages in reverse order.

Installation Instructions