Инструкции По Установке для GE PVW73

31-11007

3

FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE 

PROPERLY GROUNDED.
Remove house fuse or open circuit breaker 

before beginning installation.
Do not use an extension cord or adapter plug 

with this appliance. Follow National Electrical 

Codes or prevailing local codes and ordinances.

These vent hoods must be supplied with 120V, 

60Hz, and connected to an individual, properly 

grounded branch circuit, and protected by a 15 

or 20 amp circuit breaker or time delay fuse.
• Wiring must be 2 wire with ground.
•  If the electrical supply does not meet the above 

requirements, call a licensed electrician before 

proceeding.

•  Route house wiring as close to the installation 

location as possible in the ceiling or wall. 

•  Connect the wiring to the house wiring in 

accordance with local codes.

The grounding conductor must be connected to 

a ground metal, permanent wiring system, or an 

equipment-grounding terminal or lead on the hood.

 The improper connection 

of the equipment-grounding conductor can result 

in a risk of electric shock. Check with a qualified 

electrician or service representative if you are in 

doubt whether the appliance is properly grounded.

Duct Install Planning
•  This hood is designed to be vented vertically 

through the ceiling. Use a 6" round duct. Use 

locally supplied elbows to vent horizontally 

through the rear wall. 

• Use metal ductwork only.
• Determine the exact location of the vent hood.
•  Plan the route for venting exhaust to the 

outdoors. To maximize the ventilation 

performance of the vent system:

1.  Minimize the duct run length and number of 

transitions and elbows.

2. Maintain a constant duct size.
3.  Seal all joints with duct tape to prevent any 

leaks.

4. Do not use any type of flexible ducting.

•  Install a wall cap or roof cap with damper 

at the exterior opening. Purchase the wall or 

roof cap and any transition and length of duct 

needed in advance.

•  When applicable, install any makeup 

(replacement) air system in accordance 

with local building code requirements. Visit 

GEAppliances.com for available makeup air 

solutions.

Recirculation Install Planning
A recirculation duct (included) and one charcoal 

filter (not included) are necessary for recirculation 

installation.
Power Supply Planning
The location of the power supply connection is 

called out in the Prepare the Wall section on 

page 6.