Инструкции По Установке для Prestige PLBN48240
6
Planning the location for your Pro Line Hood
Select the proper height to mount the hood. Take into consideration the stature of the
person or persons who will be cooking. A height of 30" to 36" above the cooking
surface will suit most users. If mounted at a height greater than 36" above the cooking
surface, the hood should be at least 6" wider than the cooking appliance to provide a
proper capture of heat and grease. (Refer to the range manufacturer's guidelines) Once
the proper height is established, draw a level line where the bottom of the hood will rest.
If practical, mount a board equal to the width of the hood along the line so you may rest
the hood on it while installing.
person or persons who will be cooking. A height of 30" to 36" above the cooking
surface will suit most users. If mounted at a height greater than 36" above the cooking
surface, the hood should be at least 6" wider than the cooking appliance to provide a
proper capture of heat and grease. (Refer to the range manufacturer's guidelines) Once
the proper height is established, draw a level line where the bottom of the hood will rest.
If practical, mount a board equal to the width of the hood along the line so you may rest
the hood on it while installing.
Mark a centerline on the wall equal to the entire height of the hood to assist with the
proper duct alignment and hood placement. Determine stud location and mark it clearly.
If only one stud can be located, toggle bolts or additional fastening must be installed to
firmly secure the hood to the wall. Install a 115 volt 15 amp electrical lead in the hole
marked on the rough-in diagram. (Fig. A) The hole is located on the centerline of the
hood. The center of the hole is 3” up from the bottom of the hood and the radius is 7/8”.
proper duct alignment and hood placement. Determine stud location and mark it clearly.
If only one stud can be located, toggle bolts or additional fastening must be installed to
firmly secure the hood to the wall. Install a 115 volt 15 amp electrical lead in the hole
marked on the rough-in diagram. (Fig. A) The hole is located on the centerline of the
hood. The center of the hole is 3” up from the bottom of the hood and the radius is 7/8”.
Figure
A