Использование И Уход для Viking VCRB5363RCB

Скачать
Страница из 20
14
Pr
oduct Car
e
Cleaning & Maintenance
   Your refrigerator is built to give you many years of dependable service. However, there are a few things you can do to help 
extend its life. This section tells you how to clean your refrigerator and what to do when going on vacation, moving, or during 
a power outage.
Interior Surfaces
Wash the interior surfaces of your refrigerator with four tablespoons of baking soda dissolved in one quart of warm water. Use 
a soft, clean cloth. Rinse these surfaces with warm water, and dry with a soft clean cloth.
DO NOT use the following to clean interior surfaces:
 
• Abrasive or harsh cleaners, such as ammonia or chlorine bleach
 
• Concentrated detergents or solvents 
 
• Metal scouring pads
These products can scratch, crack and discolor your refrigerator’s surfaces. Also, NEVER wash the ice bucket or shelves in the 
dishwasher. They must be cleaned by hand.
CAUTION
 To avoid personal injury or property damage, read and follow all 
cleaning product manufacturer’s directions.
WARNING
T  o avoid electrical shock which can cause severe personal injury or 
death, turn power disconnect switch to OFF before cleaning. After 
cleaning, return power disconnect switch to ON position.
 Glass Shelves
  To clean your refrigerator’s glass shelves, lift the shelf out by lifting the front and releasing the hooks from the metal track. 
Then pull the shelf out. Be sure to allow the glass shelves to adjust to room temperature before cleaning.
To clean crevices, dilute mild detergent with water. Brush this solution into crevices using a plastic bristle brush. Let set for 
fi ve minutes. Spray warm water into crevices using faucet spray attachment. Dry glass shelf thoroughly and replace shelf by 
inserting hooks into metal track and lowering front.   
Door Gaskets
Clean the door gaskets every three months using the same procedures used for interior surfaces. You should apply a light 
fi lm of petroleum jelly to keep gaskets pliable.
Defrost Pan
To prevent condensation from overfl owing, check defrost pan periodically.
To check defrost pan, remove two screws securing kickplate to unit. Pull defrost pan forward until it stops. Remove any excess 
water from pan. Wipe and clean defrost pan with a sponge. Return defrost pan to original position. Return kickplate to unit 
by securing with two screws.