Инструкции По Установке для Liebherr HC1030

Electrical shock hazard!

u

Start-up should only take place once the appliance has

been installed according to these instructions.

u

Electrically ground appliance.

u

Do not ground to a gas pipe.

u

Check with a qualified electrician if you are not sure the

appliance is properly grounded.

u

Do not have a fuse in the neutral or grounding circuit.

u

Do not use an extension cord, power bar or a multiple

socket adapter.

u

Do not use a power cord that is frayed or damaged.

Electrical shock hazard!

This appliance is equipped with a three-prong (grounding)

polarized plug for your protection against possible shock

hazards. Electrical Grounding Required.

u

Do  not  remove  the  round  grounding  prong  from  the

plug.

u

Use only an grounded adapter.

- Wait  1  hour  after  installation  before  you  plug  in  the

appliance. This allows the refrigerant and system lubri-

cation to reach equilibrium.

- Make sure incoming voltage is the same as the appli-

ance rating. A 110-120 Volt, 60 Hz, 15 Amp electrical

supply  (20  Amp  for  side-by-side  installations)  circuit

that is controlled by a circuit breaker or fuse is required.

- We recommend using a dedicated circuit for this appli-

ance to prevent electrical overload.

- Follow  all  Federal,  State  and  local  electrical,  fire  and

building  codes  and  ordinances  when  installing  the

receptacle and / or the appliance.

- In some communities, a wall switch is required to turn

power to the appliance ON and OFF.

- To  reduce  the  risk  of  fire,  electric  shock,  or  personal

injury,  installation  work  and  electrical  wiring  must  be

done  by  a  qualified  electrician  in  accordance  with  all

applicable  codes  and  standards,  including  fire-rated

construction.

- The Power Plug must be easily accessible so that the

appliance can be disconnected from the mains quickly

in an emergency. It must not be behind the back of the

appliance.

- The  top  of  the  electric  outlet  must  be  located  within

82-5/8  in.  (2100  mm)  from  the  top  of  the  base  in  the

cabinet.