Справочник Пользователя для Vinotemp VTIMSW

6 

 

 

 

•  Remove all exterior and interior packing materials. 

•  Check to be sure you have all of the following parts: 

•  1 Ice Bucket 

•  1 Plastic Scoop 

•  25 ft. hose 

•  1 instruction manual 

 

•  Before connecting the ice maker to the power source, let it stand upright for 

approximately 2 hours. This will reduce the possibility of a malfunction in the 
cooling system from handling during transportation. 

•  Clean the interior surface and ice bucket with lukewarm water using a soft cloth. 

 
Installation Of Your Ice Maker 

•  This appliance is designed to be recessed or built-in (fully recessed) or 

freestanding. 

•  Place your ice maker on a flat surface that is strong enough to support the unit 

when fully loaded.  

•  Level your ice maker by adjusting the legs at the front of the unit. 

•  Do not place the unit in a moist place. Too much moisture in the air will cause frost 

to form quickly on the evaporator, requiring more frequent defrosting of the 
appliance. 

•  Locate the ice maker away from direct sunlight and sources of heat (stove, heater, 

radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may 
increase electrical consumption. Extreme cold ambient temperatures may also 
cause the ice maker not to perform properly. 

•  Position appliance to allow airflow through the front grill (see 

SKETCH 1) 

 

 

•  Not all of the hardware necessary for installation has been provided. It is necessary 

to hire a professional licensed plumber to complete the installation. 

•  Connect tubing (supplied with the unit) to the nearest cold water source. Connect 

sufficient tubing to the unit to allow the appliance to be moved freely for cleaning 

and service. Also, make sure that the tubing is not pinched or damaged during 
transportation and installation. 

 

 

SKETCH 1