Техническая Спецификация для KitchenAid KRFF300ESS

A light bulb is loose in the socket or 
burned out 

Tighten or replace the light bulb. See “Changing the Light 
Bulbs.”

The dispenser light is set to OFF

On some models, the dispenser light will operate only when a 
dispenser paddle is pressed. If you want the dispenser light to 
stay on continuously, see “Water Dispenser.”

The control is set to Sabbath Mode (on 
some models)

Turn off Sabbath Mode. See “Using the Controls.”

Below are listed some normal 
sounds with explanations.

The compressor in your new refrigerator regulates 
temperature more efficiently while using less energy, and 
operates quietly. Due to the reduction in operating noise you 
may notice more intermittent noises. 

Sound of the compressor 
running longer than expected

High efficiency compressor and fans

This is normal. Larger, more efficient 
refrigerators run longer. 

Pulsating/Whirring

Fans/compressor adjusting to optimize performance during 
normal compressor operation

This is normal

Popping

Contraction/expansion of inside walls, especially during initial 
cool-down

This is normal

Hissing/Dripping

Flow of refrigerant, or flow of oil in the compressor 

This is normal

Vibration

The refrigerator may not be steady

Adjust the leveling screws and lower 
the leveling foot firmly against the floor. 
See “Door Closing and Door 
Alignment.”

Rattling/Banging

Movement of the water lines against the refrigerator cabinet, 
or of items placed on top of the refrigerator cabinet

Move excess water line away from the 
refrigerator cabinet or fasten excess 
tubing to the cabinet. See “Connect 
the Water Supply,” or remove items 
from the top of the refrigerator.

Sizzling

Water dripping on the heater during defrost cycle

This is normal

Water running/Gurgling

May be heard when ice melts during the defrost cycle and 
water runs into the drain pan

This is normal

Buzzing

Heard when the water valve opens to fill the ice maker

This is normal

Creaking/Cracking

May be heard as ice is being ejected from the ice maker mold This is normal

Ker-plunk

May be heard when the ice falls into the ice storage bin

This is normal

The refrigerator has just been installed

Allow 24 hours following installation for the refrigerator to cool 
completely.

Cooling is turned off

Turn on cooling. See “Using the Controls.”

The controls are not set correctly for 
the surrounding conditions

Adjust the controls a setting colder. Check the temperature in 
24 hours. See “Using the Control(s).”

The door(s) are opened often or not 
closed completely

Allows warm air to enter refrigerator. Minimize door openings 
and keep doors fully closed.

A large load of food was recently 
added

Allow several hours for refrigerator to return to normal 
temperature.