Инструкции По Установке для VintageView Vino Pins for Drywall Surfaces (with Collars)
For product warranty information, please visit:
VintageView.com/support/warranty
We’re here to help, call us at 866-650-1500 with any questions.
US Patents: 6,991,117 and 7,850,017 China Patent: ZL 2006 2 0173305.3
Figure G
4. Assemble the Vino Pins - If using Vino Pins
extensions*, thread a stud into one end of the base
extension pin and screw the starter base Pin onto the
remaining exposed end and firmly hand tighten (Figure
E). Connect any additional extensions in a similar fashion
and repeat this process for the neck pins. Place the Vino
Pins Collar over the toggle bolt with the open side facing
the nut. Thread the assembled Vino Pins or the Vino Pins
starter onto the toggle bolt. (Figure F).
5. Install Pins - Locate the lower of the 2 anchor holes
in your wall and ensure that you have the base side Vino
Pin assembly (the side with the longer curve in it) (Figure
G). Push the head of the bolt through the drywall until the
Vino Pins Collar is flush against the wall surface. Gently pull
back on the Vino Pin to hold the wings of the expanding
nut against the back side of the drywall and center the bolt
in the anchor hole while turning the Vino Pin clockwise to
firmly hand-tighten in place. Repeat the process for the
neck pin in the higher anchor hole (Figure H).
Figure E
Figure H
Figure F
*Optional
Extensions
Install the Machine/Lag studs - Thread 2 nuts onto
the fine threaded end of one Machine/Lag Studs and using
two 7/16” wrenches, tighten the nuts against one another
(Figure I). With the nuts tightend against each other, use
one wrench on the outer nut and thread the lag end into
the pilot hole in the wall. Screw the bolt into the wall until
the coarse threads of the lag screw end are no longer
visible, leaving just the finer threads exposed (Figure J).
Again using 2 wrenches, loosen the nuts and remove them.
Figure I
Figure J
Figure L
Figure K
Wall Stud Mounting
Assemble the Vino Pins and Install - Slide a collar over
the stud protruding from the wall with the open cavity
facing the wall surface (Figure K). If using Vino Pins
extensions, refer to step 4 above. Thread the assembled
Vino Pins or the Vino Pins starter onto the stud extending
from the wall, ensuring that the base side is secured to the
lower stud and the neck pin attaches to the higher stud
and firmly hand tighten (Figure L). Return to step 3.
*IMPORTANT NOTICE: The Vino Pins are designed to accommo-
date a maximum of 3 bottles deep - 1 starter plus 2 extensions.
Any application outside of these parameters is not warranted by
VintageView and may result in product and/or installation failure,
property damage and/or bodily injury.