Справочник Пользователя для Philips DTM3170/12
9
EN
Note
•
If you are not going to use the remote control for a
long time, remove the battery.
•
Batteries contain chemical substances, so they should
be disposed of properly.
Set clock
1
In standby mode, press and hold CLOCK
for more than two seconds to activate the
clock setting mode.
»
The 12 hour or 24 hour format is
displayed.
2
Press / to select 12 hour or 24
hour format, and then press CLOCK.
»
The hour digits are displayed and begin
to blink.
3
Press / to set the hour, and then
press CLOCK.
»
The minute digits are displayed and
begin to blink.
4
Press / to set the minute.
5
Press CLOCK to confirm.
Store radio stations
automatically
If no radio stations are stored, the unit can store
radio stations automatically.
1
Turn on the unit.
2
Press SOURCE to select TUNER source.
»
[AUTO INSTALL -- PRESS PLAY --
STOP CANCEL] (press
to start
automatic installation, or press to
cancel) is displayed.
3
Press
.
»
The unit automatically stores radio
stations with sufficient signal strength.
»
After all available radio stations are
stored, the first stored radio station is
broadcast automatically.
Turn on
Press .
»
The unit switches to the last selected
source.
Switch to standby
Press again to switch the unit to standby
mode.
»
The backlight on the display panel is
reduced.
»
The clock (if set) appears on the
display panel.
To switch to Eco power standby mode:
Press and hold for more than two seconds.
Press and hold for more than two seconds.
»
The backlight on the display panel
turns off.
To switch between normal standby mode and
Eco power standby mode:
Press and hold for more than two seconds.
Press and hold for more than two seconds.
Note
•
If no button is pressed over 15 minutes in standby
mode, this device goes to Eco power standby mode
automatically.