Справочник Пользователя для Cabletron Systems 8H02-16

After enabling the COM port as described in Section 6.6.11, select one of 
the four applications supported by the COM port: LM, SLIP, PPP or UPS. 
The default application is LM.

To change the COM port application: 

1. Use the arrows keys to highlight the Application field.

2. Use the SPACE bar or BACKSPACE to step through the available 

settings until the required operation appears. Table 6-2 lists the 
available settings and their corresponding applications. 

3. Press ENTER to accept the application.

4. Use the arrow keys to highlight SAVE at the bottom of the screen, then 

press ENTER.

5. When the message “SAVED OK” appears, the edits are saved. 

If the COM port is reconfigured without a valid IP address set 
on the device, the message shown in Figure 6-6 appears. Do 
not continue unless the outcome of the action is fully 
understood.

[LM]

Local Management Session

[UPS]

APC Power Supply SNMP Proxy

[SLIP]

Serial Line Interface Protocol

[PPP]

Point-to-Point Protocol