Справочник Пользователя для Crimestopper Security Products CS-9704
UNIT SHUTS DOWN 4-5 SECONDS AFTER REMOTE STARTING:
The unit does not sense the engine in Tachless mode. Turn dip switch #4 OFF and wrap the gray wire around a
plug/coil wire. The module will sense inducted RF/Engine noise in the gray wire allow the engine to stay running
longer than 4-5 seconds.
The unit does not sense the engine in Tachless mode. Turn dip switch #4 OFF and wrap the gray wire around a
plug/coil wire. The module will sense inducted RF/Engine noise in the gray wire allow the engine to stay running
longer than 4-5 seconds.
EXTENDED RANGE ANTENNA:
The supplied antenna plugs into the 4-pin connector at he far left side of the module. This antenna also
incorporates the receiver and therefore must be connected or the system will not operate. The antenna should be
mounted inside the vehicle close to the left side windshield molding on the driver’s side. With included double
side tape, mount the antenna housing to the lower end of the window in a vertical position with the single black
antenna wire coming out of the topside. Route the connector side of the cable down the window molding Extend
the protruding antenna wire fully upward, tucking it into the left window molding. This method allows for maximum
range with a low visual profile.
The supplied antenna plugs into the 4-pin connector at he far left side of the module. This antenna also
incorporates the receiver and therefore must be connected or the system will not operate. The antenna should be
mounted inside the vehicle close to the left side windshield molding on the driver’s side. With included double
side tape, mount the antenna housing to the lower end of the window in a vertical position with the single black
antenna wire coming out of the topside. Route the connector side of the cable down the window molding Extend
the protruding antenna wire fully upward, tucking it into the left window molding. This method allows for maximum
range with a low visual profile.
STARTER DOES NOT ENGAGE WHEN ARMED:
One side of external Starter Kill Relay coil must be connected to Orange wire while the other side must be
connected to Yellow Ignition wire from module.
One side of external Starter Kill Relay coil must be connected to Orange wire while the other side must be
connected to Yellow Ignition wire from module.
If an external parking light relay is used, add a 1-amp diode across relay coil (terminals 85,86). The band end
(cathode) of the diode connects to the same terminal as the White light wire.
(cathode) of the diode connects to the same terminal as the White light wire.
SIREN CHIRPS DISAPPEAR:
Remote Start button was held down too long when starting vehicle and the alarm silent arm feature was
accidentally changed. Turn ignition key on and press Remote Start button about 3 seconds to re-enable siren
chirps.
Remote Start button was held down too long when starting vehicle and the alarm silent arm feature was
accidentally changed. Turn ignition key on and press Remote Start button about 3 seconds to re-enable siren
chirps.
NO RESPONSE FROM EITHER TRANSMITTER:
Check for proper power/ground connection and check for Antenna connection. The antenna included with this
system has the receiver and antenna inside the small case therefore it must be plugged in to the main module for
the unit to receive commands from the transmitters
Check for proper power/ground connection and check for Antenna connection. The antenna included with this
system has the receiver and antenna inside the small case therefore it must be plugged in to the main module for
the unit to receive commands from the transmitters
11