Справочник Пользователя для Inter-Tel 3000
Inter-Tel 3000
Administrator’s Manual
58
The default value is set at 1.
Selecting the Number of Retry Attempts
The number of simultaneous remote notification calls can be set at 1 or 2.
• From the Programming extension, press the PROGRAM key.
• Press the Scroll Down key ( ) until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “System”.
• Select “Remote Notification”.
• Select “Retry attempts”.
• Enter the value from 2 to 15 and press “Confirm”.
The default value is set at 2.
The default value is set at 2.
Selecting the Line Group that the Remote Notification calls are to use
The outgoing line group to be used for remote notification calls can be changed.
• From the Programming extension, press the PROGRAM key.
• From the Programming extension, press the PROGRAM key.
• Press the Scroll Down key ( ) until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “System”.
• Select “Remote Notification”.
• Select “Outgoing group”.
• Select the group.
Notification delay timer
The time interval between receiving a message and making the first remote notification attempt is
programmable. This is set at 15 minutes (900 seconds) in default and can be set between 1 and 30 minutes
(60 - 1800 seconds).
programmable. This is set at 15 minutes (900 seconds) in default and can be set between 1 and 30 minutes
(60 - 1800 seconds).
• From the Programming extension, press the PROGRAM key.
• Press the Scroll Down key ( ) until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “System”.
• Select “Timers”.
• Select “Notification Delay”.
• Enter the value between 60 and 1800 seconds and press “Confirm”.
Notification interval timer
If a remote notification fails this is the time the system waits before retrying the call. This is set at 5
minutes (900 seconds) in default. The range is 1-15 minutes (60 - 900 seconds).
• From the Programming extension, press the PROGRAM key.
minutes (900 seconds) in default. The range is 1-15 minutes (60 - 900 seconds).
• From the Programming extension, press the PROGRAM key.
• Press the Scroll Down key ( ) until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “System”.
• Select “Timers”.
• Select “Notification Interval”.
• Enter the value between 60 and 900 seconds and press “Confirm”.