Toshiba H-9100N-CA 用户手册
13. OPERATING PROCEDURES
■ NOTES BEFORE STARTING OPERATION
13- 1
13. OPERATING PROCEDURES
■
NOTES BEFORE STARTING OPERATION
■
How to access REG., M.DOWN, or REWRAP menu
(1) Turn the power ON.
(2) A sixteen-second scanning will be performed after pressing the
(2) A sixteen-second scanning will be performed after pressing the
key.
(3) Should a power failure occur during the operation, remove the commodity from the platter
and insert the power plug into an AC outlet again when power is restored.
(4) If the scale is used with an unrated power source, inaccurate scaling or other errors may
occur.
(5) If the zero point has shifted while scaling, and no tare is displayed, adjust the zero point
by pressing the
key.
(6) Check the date of the scale before the daily operation.
(7) Make a test print before operation every day.
(7) Make a test print before operation every day.
Press the
key, and the test label is issued.
ZERO
TEST
POWER
The following display is displayed on the REG. menu display. When this display is shown
after pressing the
after pressing the
key, you can start the REG. operation right away.
POWER
NOTE: If a label nothing is printed on is issued after a printed label in batch mode, refer to
Section 10.11 and press the
key.
SET NEXT
To access a menu from other menus, press the
key to show the Main menu and enter
the menu No. When the MARK DOWN and REWRAP menus are protected, enter the menu
No. and then the password.
No. and then the password.
<Menu> MAIN
0. PROG.
0. PROG.
5. READ
1. REG.
6. RESET
2. MARK DOWN
7.
3. REWRAP
8.
4. SECURITY
9.
ESC
.
lb
UNIT/$
TOTAL $
0.000
P
000000
<REG.> MENU WEIGH
ENTER THE PLU#