Jacuzzi PORTABLE WHIRLPOOL SPA 用户手册

3

 Read complete instructions before beginning installation.

Because your  spa is  portable, you can locate it just about anywhere you wish--on a deck, patio, or even indoors.

Just be sure to position it above ground in an area with good drainage and on a level, continuous surface which can
support the weight of the spa when filled with water and people; this weight is approximately 4874 lbs. (86 lbs. per
square foot).  You must also provide access to the spa's equipment for service and general maintenance.

Your Spa, as it comes from the factory, requires a 230

VAC 60 AMP 4-wire grounded type electrical service
having copper connectors and must be in a  separate
circuit having no other appliance connected  in that
circuit.  If you do not have this kind of circuit, a qualified
electrician should be called in to install the necessary
wiring.  Inadequately sized wiring may cause a voltage
drop which might cause the unit to malfunction and bring
about permanent damage to the spa's electrical system.
We recommend that the wire be sized for a 3% voltage

drop. (See NEC.) Each "leg" of the incoming power to
neutral must be 105 VAC minimum at the spa when all
the spa equipment is running.   The circuit must also
have a ground wire in order to take advantage of the
designed-in safety features of the spa. A bond wire must
also be used.  Bond according to procedure described
on the next page.

32"

87"

EQUIPMENT DOOR