American Dryer Corp. WDA-385 用户手册

SECTION V

Servicing

ALL electrical/mechanical service or repairs should be made with the electrical power to the dryer

disconnected (power off).

WARNING: PERSONAL INJURY COULD RESULT

The information provided in this section should not be misconstrued as a device for use by an untrained

person making repairs. Service work should be performed by competent technicians in accordance with

local, state, and federal codes.

When contacting the factory for assistance, always have the dryer model and serial numbers available.

CAUTION: Observe ALL safety precautions displayed on the dryer or specified in this manual

before and while making repairs.

Before considering replacement, make sure that ALL connectors are in place and making proper contact.

Check input voltages and temperature sensor. After replacing any parts or performing adjustments or

service run through a complete cycle.

To Replace Control Panel Assembly

1. Disconnect power to the dryer.

2. Disconnect main power harness from rear of

computer by squeezing locking tab and pulling

connector straight back.

3. Disconnect the green ground wire from the

computer.

4. Disconnect coin acceptor optic switch connector

from 15 pin harness.

5. To remove control panel assembly from the

control box, gently tap the bottom of the control

panel upward and lift off the hinges.

6. Install new control panel assembly by reversing

this procedure.

7. Be sure to check or reset programs.

NOTE: Use caution when handling MP Controller. Easily damaged by static electricity.