American Dryer Corp. WDA-385 用户手册

37

To Replace V-Belts

1. Loosen tension on V-Belts, so that they can easily be rolled off pulleys.

2. Replace V-Belts.

3. Re-tighten V-Belts and adjust tension and alignment per previous instructions.

J. Motor

To Replace Motor

1. Discontinue power to dryer.

2. Remove drive belt.

3. Disconnect wiring harness from motor.

4. Remove nuts and washers holding the motor mount to the rear of the dryer and pull motor mount away.

5. Remove the two (2) left hand nuts on the motor shaft retaining the impeller.  Work the impeller free

from the motor shaft by means of a puller to prevent damage to the motor shaft.

6. Remove the bolts holding the motor to the motor mount and replace it with a new motor.

7. Remove pulley from old motor and install on new motor.

8. Align motor with impellor face in plane with the motor mount at no less than 3/16" clearance.

K. Impeller

NOTE: Follow steps 1 through 5, 8 in "Section V, Part N."

L. Lintscreen

To Replace Lintscreen

1. Open lint door and remove.

2. Remove the two (2) hex head screws securing lintscreen, hold down in place and remove from trap.

3. Slide Lintscreen out along the lint coop track.

4. Reverse procedure for installing new lint screen.

5. Close lint door.