Toshiba CTX28 用户手册

下载
页码 495
PCB Installation
RCOU3A, RCOS3A – Four-Circuit Loop Start CO Line Interface Unit
Strata CTX I&M        06/04
6-25
PC
B
 In
stal
latio
n
RCOU Installation
Note
The decibel (dB) Pad switches SW101, SW201, SW301, and SW401 control excessive 
loudness resulting from close proximity to a Central Office or PBX telephone office by 
providing a -3 dB signal level drop to, or from, the PBX or CO when set to the 3 position. 
Switches are factory-set to the 0 (0 dB signal level drop) position.
³ To install an RCOU3A or RCOU1A PCB
1. If the Strata CTX system is within one mile of the PBX or Central Office, set the RCOU dB 
Pad switches SW101, SW201, SW301, and SW401 to the 3 (-3 dB signal level drop) position.
2. (RCOU3A only) For Mexico, the U.K, or Asia, insert the short jumper plug on the A Law side. 
For the U.S. and Canada, no plug is required. (No plug is the Mu Law assignment).
3. Insert the RCOU (component side facing right) into the appropriate slot and apply firm, even 
pressure to ensure proper mating of connectors. PCOU2 can be installed in place of RCOU, see 
the appropriate Configuration chapter.
4. After installing the RCOU, gently pull the PCB outward. If the connectors are properly mated, 
a slight resistance is felt. 
Table 6-12
RCOU3A and RCOU1A Controls, Indicators, and Connectors
Control/Indicator/
Connector
Type of Component
Description
CO line circuit 1~4 indicators
Red LED
Lights to indicate that line circuit is in operation. 
(CO line indicator will not light unless RCOU is 
connected to a CO line).
J1 connector
Modular connector
Interface connector for CO line circuits 1 and 2.
J2 connector
Modular connector
Interface connector for CO line circuits 3 and 4.
Pad switch SW101 (circuit 1)
2-position slide switch
Enables -3dB signal level drop for CO line 
circuit.
Pad switch SW201 (circuit 2)
Pad switch SW301 (circuit 3)
Pad switch SW401 (circuit 4)
RCOS connector P11, P12, 
P13, P14
10-pin male connector
Interface connector for RCOS 4-circuit loop 
start CO line unit.
Mu Law/A Law jumper plug 
P2
(RCOU3A only)
3-terminal jumper
No jumper plug is the default for the U.S. and 
Canada. For countries requiring A Law, insert 
the jumper plug (provided in the PCB box) on 
the A Law side.