Toshiba CTX28 用户手册
Station Apparatus
Tilt Stands
11-26
Strata CTX I&M 06/04
Tilt Stand for DKT/IPT + Two ADMs
Use Tilt Stand models “BTSA” for DKTs or IPTs with one or two ADMs.
³ To attach a Tilt Stand to a 3000-series DKT, IPT1020-SD with two ADMs
1. Complete the steps under
2. Make sure bottom phone jack is plugged in.
4. Place the spacers on the outer holes, as shown (see
).
5. Attach Tilt Stand to bottom of DKT with screws.
6. Reinstall the Tilt Stand Base: Fit the Tilt Stand Base over the Tilt Stand so that the “bottom
pegs” fit into the holder. Adjust Tilt Stand so that the “top pegs” fit into the top Tilt Stand Base
holes. Do this to both stands.
holes. Do this to both stands.
7. Pull up on the Tilt Stand Bases so that they open to the maximum angle (30 degrees). See
.
8. Push in the Lock Release button to adjust the tilt angle (0, 10, 20 or 30 degrees) of each Tilt
Stand.
Figure 11-22 Attach Tilt Stands to DKT/IPT with Two ADMs
6527
PHONE
1 ADM
(A)
Spacer
Spacer
2 ADM
1 ADM
2 ADM
PHONE
PHONE
DKT
DKT
1 ADM
2 ADM
2 ADM
1 ADM
2 ADM
2 ADM
PHONE
PHONE
PHONE
(A)
Spacer
Spacer
2 ADM
1 ADM
1 ADM
2 ADM
2 ADM
1 ADM
2 ADM
2 ADM
2 ADMs + 1 DKT (or 1 IPT)
Put in three screws in the
positions marked “PHONE.”
positions marked “PHONE.”
Insert a spacer beneath each stand as shown. Put in the
screw with the spacer first. Then insert the other two screws.
screw with the spacer first. Then insert the other two screws.
Put in three screws in the
positions marked “2ADM.”
positions marked “2ADM.”
ADMs
DKT/IPT