Lucent Technologies 3100 用户手册
Configuration
Issue 1 October 1998
5-5
How to connect to the ADMIN Port
Introduction
Required cable
IMPORTANT;
RS-232 cable
length should
not exceed
50 ft.
RS-232 cable
length should
not exceed
50 ft.
Using the
Switch
Management
Interface
Switch
Management
Interface
The ADMIN port provides a direct connection to all
features and functions of the Switch Management
Interface and the ability to configure, monitor and
troubleshoot all Switch Cards in the Rack.
features and functions of the Switch Management
Interface and the ability to configure, monitor and
troubleshoot all Switch Cards in the Rack.
A standard RS-232 serial straight-through (DB-9, Male)
cable is required. Use this cable to connect the PC’s
COM port to the ADMIN Port (P110) on the back of the
Rack. (see Figure 5.1 below)
cable is required. Use this cable to connect the PC’s
COM port to the ADMIN Port (P110) on the back of the
Rack. (see Figure 5.1 below)
Note: This connection must be used in conjunction with
the Switch Management Interface.
the Switch Management Interface.
Before using the Switch Management Interface, you must
first do the following:
first do the following:
q
install the Switch Management Interface (next page)
q
confirm that the Switch Management Interface
settings must match your PC’s COM port settings.
(see page 5-30)
settings must match your PC’s COM port settings.
(see page 5-30)
Figure 5.1. RS-232 Connection
Connect to the COM port
on the PC
on the PC
ADMIN Port
(P110)
(P110)
Connect to COM
port on the PC.
port on the PC.