3M 700 Series 用户手册
System Operation
Turning the System On
Follow these steps to turn the system on:
1.
Ensure that the power cord is connected to a power outlet.
2.
Allow 15 seconds for the system to warm up.
Turning the System Off
Remove power from the system by one of the following methods:
• Disconnect the AC power cord from the power outlet.
• Set the facility circuit breaker for the system to the Off position.
Verifying system operation
Inspect your system daily for proper operation. To verify system operation, walk through the system corridor with a secured
library item. This should result in an audible alarm and a flashing alarm light at the top of the lattices. There is no need
for repetitive walk-through testing.
library item. This should result in an audible alarm and a flashing alarm light at the top of the lattices. There is no need
for repetitive walk-through testing.
Fuse replacement
The fuses are located on the side above the power cord of the electronics enclosure.
1.
Disconnect the power cord from the power source.
2.
Using a small flat-blade screwdriver, remove the fuse holder.
3.
Replace the failed fuses with a 5A 250V 5mmx20mm glass fuse.
4.
Reinstall the fuse holder, and connect the power cord to the power source.
©2008. 3M. All rights reserved.
13